Decograde Concrete Resurfacing Call (02) 9090 4131

Spray On Concrete Resurfacing Revesby

Free phone consultation, no obligation.

Licensing & insurance checked before joining our networkCanterbury-Bankstown service area

Last updated: 4 October 2026

Decograde Concrete Resurfacing applies spray-on concrete finishes in Revesby. A cement-based coat is sprayed over a prepared slab, textured and sealed, which suits paths, entries and courtyards that are solid but tired. Call (02) 9090 4131 to talk it through.

Where spray-on fits in Revesby

Revesby grew from post-war fibro bungalows, per the suburb’s Wikipedia entry, and older blocks like these have front paths, side paths and small entries close to the house. Spray-on is thin, so it keeps the existing levels and edges and goes around fixtures and walls without lifting anything.

Colour and pattern

A single mid-tone is the baseline. A border, a second tone or a stencil adds hours and cost. We bring sample boards and suggest you look at them outside in daylight before you choose.

Questions about your specific surface or budget? Call (02) 9090 4131 — no obligation.

What the layer copies

Spray-on is thin, so it copies what is under it. Cracks, stains and loose patches show through unless repaired first, so we clean, strip, repair and etch every time. That preparation decides how long the finish lasts.

Plain or patterned? Tell us about the area and we will talk through both on (02) 9090 4131.

Entries and steps

Steps and thresholds are measured separately. Edges are masked tight and tape lines are lifted by hand, and we repair chipped step edges first so the new surface has a crisp line.

Sealing and upkeep

Sealer protects against stain and UV and makes the surface easier to wash. We name it in the estimate. Wash with water and a mild cleaner, sweep regularly and avoid harsh chemicals.

How long a small job takes

A path or entry can be done in a day or two, with cure time after. Patterns add hours. We give you a schedule with the estimate and tell you when the surface can take foot traffic and furniture.

Not sure which option fits your situation? Call (02) 9090 4131 and talk it through with a contractor.

Is it the right finish for you?

Spray-on suits solid slabs that need a fresh face. It is not the answer to a crumbling surface or a slab that is still moving, and we say so if yours is one of those.

Our spray-on resurfacing page covers the method, and the spray-on cost guide covers pricing.

Spray-on beside other finishes

Spray-on is a lower-cost route than a thicker pebble finish and it allows a wide range of colour and pattern. It is not the answer for a crumbling surface or a moving slab. We compare it with the other options on your slab and say plainly which one we would choose.

Still weighing your options? Call (02) 9090 4131 for a straight answer.

What to put to a spray-on contractor

Put four questions to anyone quoting: how many coats and which sealer, what preparation is included, when the surface takes foot traffic, and whether the colour on show was a sample or a finished job. Our estimate answers all four in writing.

Narrow side paths and rear courtyards are well suited to spray-on, because the thin layer can be masked tight against walls and fences. We protect render, plants and fence bases and tell you what to move before we arrive. A tidy site at the end of each day matters to the neighbours, and we leave it that way.

Answers to common questions

Can I do a small entry only?

Yes. Small areas suit a stencil well, and we price them on their own. Tell us the size and we will say what is sensible.

How is spray-on different from paint?

It is a cement-based coat that bonds to the slab and is sealed. Paint is a thin film that tends to peel. We explain the difference and show samples.

Will it cover a fibro-era patched path?

Once patches are cut back and redone, yes. We check each repair and replace any that has failed.

Do you spray in cold weather?

We avoid very cold or wet days because the product sets best in mild, dry conditions. We reschedule if needed.

Can spray-on go along a narrow side path?

Yes. We mask the walls and fences, spray the path in sections and keep overspray off neighbouring surfaces.

Get a spray-on estimate in Revesby

Send the area, the look you want and a photo of the slab. We will give you a written estimate.

Request a practical quote

Share the suburb, service and a few surface details. Prefer to talk? Call (02) 9090 4131.